USIM Card Installation

USIM Card is an IC card containing customer and authentication information, including handset phone number.

SD/USIM Card Insertion/Removal Tool

There are two inscriptions (one for USIM and one for SD) on included SD/USIM Card Insertion/Removal Tool (hereafter "Insertion/Removal Tool"). Align the USIM side over the back of handset.

  • Always use included Insertion/Removal Tool for USIM Card installation. Using other devices may damage handset and USIM Card. Take care not to lose Insertion/Removal Tool.

Inserting USIM Card

Always power off beforehand.

  • Open Card Slot Cover

  • Insert USIM Card into USIM Card Slot (bottom opening)

  • Check orientation of USIM Card, then insert it as shown.

  • Align Insertion/Removal Tool with Card Slot, with the USIM side (USIM挿抜時：この面が背面側) facing down

  • Take care not to get Card Slot Cover caught between handset and Insertion/Removal Tool.

  • Gently push in Insertion/Removal Tool until it clicks

  • After inserting USIM Card properly, pull back Insertion/Removal Tool slowly.

  • Close Card Slot Cover

  • Close Card Slot Cover firmly. Debris trapped between gasket and base may allow ingress of liquid.

Removing USIM Card

Always power off beforehand.

  • Open Card Slot Cover

  • Align Insertion/Removal Tool with Card Slot, with the USIM side (USIM挿抜時：この面が背面側) facing down

  • Take care not to get Card Slot Cover caught between handset and Insertion/Removal Tool.

  • Gently push in Insertion/Removal Tool until it clicks

  • Pull back Insertion/Removal Tool slowly (USIM Card pops out slightly). Pulling it back quickly may make USIM Card jump out.

  • Remove USIM Card

  • Close Card Slot Cover

  • Close Card Slot Cover firmly. Debris trapped between gasket and base may allow ingress of liquid.